Metrologic Instruments FOCUSE IS1650 User Manual download pdf (Page 32)

TROUBLESHOOTING GUIDE

The following guide is for reference purposes only. Contact a Metrologic

representative at 1-800-ID-Metro or 1-800-436-3876 to preserve the limited

warranty terms.

All Interfaces

IS1650 Series Troubleshooting Symptom / Solution Chart

Symptoms Possible Causes Solution

No power is being

supplied to the

scanner.

Check transformer, outlet and

power strip. Make sure the cable

is plugged into the scanner.

No LEDs, beep

or illumination

No power is being

supplied to the

scanner from the host.

Some host systems cannot supply

enough current to power the 1650.

A power supply may be required.

The wrong

communication cable

has been used.

Check that the communication

cable matches the unit type and

scanner configuration.

There has been a

scanner configuration

failure.

Contact a Metrologic service

representative, if the unit will not

hold the saved configuration.

Long Razz tone

on power up

There has been a

diagnostic failure.

Contact a Metrologic service

representative, if the unit will not

function.

Long Razz tone

when exiting

configuration

mode

There was a failure

saving the new

configuration.

Re-try to configure the scanner.

Contact a Metrologic service

representative if the unit will not

hold the saved configuration.

Long Razz tone

There is a scanning

mechanism failure.

Contact a Metrologic service

representative.

Short Razz tone

in configuration

mode

An invalid bar code

has been scanned.

Scan a valid bar code or quit

configuration mode.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 51 52

Comments to this Manuals

No comments

Metrologic Instruments FOCUSE IS1650 User Manual Page 32

Comments to this Manuals