Metrologic Instruments MS2xxx User Manual download pdf (Page 6)

1

IMPORTANT NOTES - BEFORE YOU START

It is important to carefully read the notes marked with a

symbol on the pages

contained in this manual. Not all configuration codes are designed to be used for

both a single and dual cable scanner/scale system. Many of the configuration

bar codes require additional steps before the unit can be configured and placed

into service. Most of the bar codes in this addendum were designed to be used

with a Stratos model that includes a scale. The text marked with a

symbol will

provide important additional information about the restrictions and uses of the bar

codes shown.

All of the bar codes in this manual require:

• The scanner/scale to have a firmware number of 14996 or higher

• All configuration bar codes must be scanned with the vertical window

The bar codes (starting with 996) located on pages 5 - 19 also

require the scanner/scale to:

• Be in scale program mode (see page 2)

• Be calibrated, sealed and certified by local Weights and Measures

authorities after the scale configuration process has been completed.

The scanner/scale can not be placed in service until it is sealed and

certified by the proper authorities.

For further details on calibration procedures for Weights and Measures

certification, refer to the Scale Operation: Calibration section of the

Stratos Installation and User’s Guide.

The certification of the weighing mechanism of the scale version of

this scanner is subject to federal, state and local Weights and

Measures statutes and regulations and can only be performed by

authorized government agencies and/or their duly registered

agents. Each time the scale or weighing mechanism is calibrated,

it should be properly sealed with a paper seal or a wire seal prior to

being placed into service in commerce.

It is the responsibility of the owner of the scale to confirm

compliance with the relevant Weights and Measures statutes and

regulations applicable in your area by checking with the appropriate

government agency before placing a newly calibrated unit into

service or removing any official seals.

1 2 3 4 5 6 7 8 9 10 11 ... 87 88

Comments to this Manuals

No comments