Metrologic Instruments MS1890 User Manual download pdf (Page 13)

NSTALLING THE

CANNER TO THE

OST

YSTEM

Stand Alone Keyboard MS1890-47

1. Turn off the host device.

2. Plug the male 10-pin RJ45 end of the

PowerLink cable into the 10-pin socket

on the MS1890. There will be an

audible click when the connector lock

engages.

3. Slide the protective cable boot up the

cable, over the connector and onto the

end of scanner handle.

4. Plug the other end of the

communication cable into the host’s

keyboard port.

5. Plug the external power supply into the

power jack on the PowerLink cable.

Check the AC input

requirements of the power

supply to verify the voltage

matches the AC outlet. The

outlet must be located near

the equipment and be easily

accessible.

6. Connect AC power to the transformer.

7. The MS1890 will start to initialize. All LEDs (yellow, white, and blue) will

light for approximately 2 seconds then start to flash alternately. When the

scanner has finished initializing the LEDs will stop flashing and the unit will

beep 3 times indicating that the scanner is ready for use.

8. Turn on the host device.

Plugging the scanner into a port on the host device does not guarantee

that scanned information will be communicated properly to the host

device. The scanner is shipped from the factory configured with default

settings. Please refer to the MetroSelect Single-Line Configuration

Guide (

MLPN

00-02544) or MetroSet2’s help files for instructions on

changing the scanner’s configuration. In addition, please check that the

scanner and host system are using the same communication protocol.

See page 6.

Figure 7.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Comments to this Manuals

No comments

Metrologic Instruments MS1890 User Manual Page 13

Comments to this Manuals

Related products and manuals for Bar code readers Metrologic Instruments MS1890