Metrologic Instruments MS1890 User Manual download pdf (Page 15)

NSTALLING THE

CANNER TO THE

OST

YSTEM

Integrated USB:

Full Speed MS1890-40

Low Speed MS1890-38

1. Turn off the host device.

2. Plug the male 10-pin RJ45 end of the

USB cable into the 10-pin socket on

the MS1890. There will be an audible

click when the connector lock engages.

3. Slide the protective cable boot up the

cable, over the connector and onto the

end of scanner handle.

4. Plug the USB type A end of the USB

cable into the host’s USB port.

5. Turn on the host device.

6. The MS1890 will start to initialize.

All LEDs (yellow, white, and blue) will

light for approximately 2 seconds then

start to alternately flash. When the

scanner has finished initializing the

LEDs will stop flashing and the unit

will beep 3 times indicating that the

scanner is ready for use.

As a default, the MS1890-38 leaves the factory with USB Keyboard

Emulation Mode enabled.

For information on configuring the MS1890-38 for USB Serial Emulation

Mode, please refer to the USB section of the MetroSelect Single-Line

Configuration Guide (

MLPN

00-02544).

Plugging the scanner into a port on the host device does not guarantee

that scanned information will be communicated properly to the host

device. The scanner is shipped from the factory configured with default

settings. Please refer to the MetroSelect Single-Line Configuration

Guide (

MLPN

00-02544) or MetroSet2’s help files for instructions on

changing the scanner’s configuration. In addition, please check that the

scanner and host system are using the same communication protocol.

See page 6.

Figure 9.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Comments to this Manuals

No comments

Metrologic Instruments MS1890 User Manual Page 15

Comments to this Manuals

Related products and manuals for Bar code readers Metrologic Instruments MS1890