Metrologic Instruments MS1890 User Manual download pdf (Page 17)

CANNER

PERATION

Audible

Indicators

When the MS1890 is in operation, it provides audible feedback. These sounds

indicate the status of the scanner. Eight settings are available for the tone of the

beep (normal, 6 alternate tones and no tone). To change the tone, refer to the

MetroSelect Single-Line Configuration Guide,

MLPN

00-02544 or MetroSet2’s

help files.

One Beep

When the scanner successfully reads a bar code it will beep once and the

white LED will turn on indicating data is being transmitted.

If the scanner does not beep once and the white light does not turn on, then

the bar code has not been successfully read.

Short Razzberry Tone

This tone is a failure indicator (see Failure Modes on page 15).

Long Razzberry Tone

This tone is a failure indicator (see Failure Modes on page 15).

Three Beeps - At Power Up

When The MS1890 first receives power it will start an initialization sequence.

All LEDs (yellow, white, and blue) will light for approximately 2 seconds then

start to alternately flash. When the scanner has finished initializing the LEDs

will stop flashing and the unit will beep 3 times indicating that the scanner is

ready for use.

Three Beeps - Configuration Mode

When entering configuration mode, the white LED will flash while the scanner

simultaneously beeps three times. The white and blue LEDs will continue to

flash while in this mode. Upon exiting configuration mode, the scanner will

beep three times, and the LEDs will stop flashing.

When configured, 3 beeps can also indicate a communications timeout during

normal scanning mode.

When using single-code-configuring, the scanner will beep three times:

a normal tone followed by a short pause, a high tone and then a low tone.

This indicates that the single configuration bar code has successfully

configured the scanner.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

No comments

Metrologic Instruments MS1890 User Manual Page 17