Metrologic Instruments MS1890 User Manual download pdf (Page 9)

NTRODUCTION

The PowerLink Cable

Connecting

Important: If the PowerLink cable is not fully latched, the unit can

power intermittently.

Figure 2. Connecting the PowerLink Cable

1. Insert the 10-pin RJ45 end of the cable into the socket on the MS1890.

There will be an audible click when the connector locks into place.

2. Gently pull on the cable strain relief to insure the cable is installed.

3. Install the cable boot cover over the cable strain relief and onto the end of

the unit’s handle.

Disconnecting

Before removing the cable from the scanner, Metrologic recommends that the

power on the host system is off and the power supply has been disconnected

from the PowerLink cable.

Figure 3. Releasing the PowerLink Cable

1. Remove the cable boot to reveal the cable connection.

2. Locate the small ‘pin-hole’ on the handle of the unit near the cable.

3. Bend an ordinary paperclip into the shape shown above.

4. Insert the paperclip (or other small metallic pin) into the small ‘pin-hole’.

5. There will be a faint ‘click’ when the lock releases. Pull gently on the

strain-relief of the PowerLink cable to remove the cable from the unit.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

No comments

Metrologic Instruments MS1890 User Manual Page 9